Kind time of the day dear friends!

Long time since I had no posts on the topic of home-making on Arduino. Frankly, I neglected this matter a little. All the time I'm eating modeling in Blender, I hope you are watching my success :) Well, if not, then you have every chance to look at them, strolling through the pages of my blog.

Well, about Arduino. The co-worker was brought spare parts from the information board. Such at the currency exchange offices are used. The kit is not quite complete, the control board does not work - the microcontroller burned. In the presence there were 3 four-digit panels with seven-segment indicators, made on red LEDs (as the phrase was wrapped up). The board with the registers for them, fortunately turned out to be working.

After reflection, a collective decision was made to build a weather station based on the BME280 and 18B20 sensors. It is understood that Arduino was chosen to manage all this cuisine.

Perhaps this is my cross, to write under Arduino all sorts of hours and weather stations. Well, no diversity ...

The resulting design can show the time, the temperature outside the window, the temperature in the room, as well as atmospheric pressure and humidity.

Our photo is below:
https://i.goldvoice.club/0x0/https://i.imgur.com/2a6XdxP.jpg

Filling a little closer:
https://i.goldvoice.club/0x0/https://i.imgur.com/T5nFo1J.jpg

During the adjustment Arduino died, changed the Atmega on it, but the CH340 chip was not found, so they connected to it through the com-port :)

If it's interesting, then I can share and sketch for it all.

Thank you all for your attention and do not forget to subscribe to my blog. I will be grateful for the repost.